bwilbert - Browse Comments

Reply to Sony KP46WT510 with 8 blinks on March 5, 2008

It is a easy swap if you want to do it youself. The part cost 85$

Reply to Help with my sont projection television on March 5, 2008

8 blinks usually means a high voltage distribution block being bad. It is the block with all the red wires in it above the D board.

Reply to Sony KP46WT510 with 8 blinks on March 3, 2008

Check the High Voltage distribution block above the D board. The resistance to gnd should be higher than 40 mega ohms. To get the wires out, you need to push in and twist.

Reply to Sony KP-65WS510 No Picture Power ON, Blink 8 Times on March 2, 2008

I got mine from www.partstore.com . Just put the part no off of the block and search. part# on mine was 8-598-955-32

Reply to Sony KP-65WS510 No Picture Power ON, Blink 8 Times on March 2, 2008

First I would unplug the high votage leads from the distro block and measure the resistance. plain and simple.

Reply to Sony KP-65WS510 No Picture Power ON, Blink 8 Times on March 2, 2008

The light will only light for a flash, in the beginning startup cycle. Then the set sees the resistance and shuts down. If you never get a light, I would look on the flyback side...

Reply to Sony KP-65WS510 No Picture Power ON, Blink 8 Times on March 2, 2008

Yes that block above the d board is the high voltage block. Push the wires in and twist, they will pop out and measure the resistance from the plug to gnd. The set detects the...

Reply to Sony KP65WS500 8 Blinks on March 2, 2008

On my KP57WS510, I was told the HV block has a resistance reading of >40mohms. Mine read 11K, so ordered new one. I ring tested my fly back, good. I would get the high voltage...

Reply to Sony KP-65WS510 No Picture Power ON, Blink 8 Times on March 1, 2008

I just repaired a TV with 8 blinks. It was a RA6 chassis. The high voltage neon was coming on at startup and going off. Measure the resistance of the high voltage distribution block. Mine...

Reply to SONY KP51WS510 Suggestions?? on March 1, 2008

Put the HV block in today and TV worked fine. Just for anybody’s info. I use Bob Parkers Flyback tester and ESR meter. Love them both, good value. They can be located @ ">http://members.ozemail.com.au/~bobpar/

Reply to KP57ws510 on February 28, 2008

send it where?

Reply to SONY KP51WS510 Suggestions?? on February 28, 2008

Got the new HV block today, measured resistance to ground wire and it reads infinity. So this should fix the problem.

Reply to SONY KP51WS510 Suggestions?? on February 25, 2008

I was told the HV block has a resistance reading of >40mohms. Mine read 11K, so ordered new one. I ring tested my fly back, good. I would get the high voltage neon light at...