Web Page not found

We cannot find the web page you are looking for. Please check the related pages below for the most current information.


Search results

  1. Transmit cable tv wirelessly to next room?

    ... 2 laptops.  Any interference there?  It is  a wrt54g ver 5. I appreciate all help here, and think this site is fantastic!!  Ya done ... an analog signal anymore once they switch to a pure digital feed. Top ...

    blumaninwi - 04/05/2008 - 23:14 - 23 comments

  2. Mitsubishi WS55313 CODE 22

    ... set. They start with a letter such a R then a number such as 5, then another number such as K, then another number such as 02. Do you have a ... sell them to authorized distributors. Thanks For some feed back, hope you can provide some insight ...

    naes - 12/28/2007 - 15:58 - 14 comments

  3. 57" Sony Wide Screen Projection TV screen with a severe green hue..

    ... This 57" Sony Wide Screen Projection Tv is approx. 5 year old, model  KP-57WV600.                         ... view our local stations with the roof antenna, now that feed is coaxle cable right from the antenna and that is the only one that seems ...

    Winterlady - 11/04/2007 - 14:02 - 6 comments

  4. sony kp-46wt510 blinks 4 times

    ... that is the vertical IC, you will need to also check the b+ feed coming from the sweep power supply. Hopefully the supply did not burn out ... check pin 3 and 5 of cn8006 check pin 3 and 5 of ...

    faceface - 09/27/2007 - 12:12 - 36 comments

  5. sony KP-51WS520 problems

    ... Although, I have seen a bad plug connection cause this, or a feed back capacitor cause this problem also. I'm afraid this repair is not ... to the  tv also the line is stationary and the led blinks 5 times and only when the tv is off ...

    jamnite - 10/10/2007 - 16:07 - 13 comments

  6. Mitsubishi WT-46809

    ... and then try and get the same results. The TV is about 5 years old but has had no problems. It is an awesome tv. Thanks for your time ... and it still shuts down. The wire that I took off is the feed to the other part that has the 3 red wires marked out. Nothing has ...

    Baseballer34 - 10/11/2007 - 13:07 - 54 comments

  7. Just replace convergence IC's but cannot adjust red horizontally on Sony KP-57WS500

    ... Can i feed it off one of the Can i feed ... I have a sony kp61hs30 where I replaced both ic's, 1 5 amp pico fuse on the g board and one 3.15 amp pico fuse on the D board. I am ...

    mbrown2 - 07/03/2007 - 22:13 - 23 comments

  8. Need Service Manual For Sony KP51WS500

    ... the convergence IC's and make sure you test the voltage feed resistors that feed the + and - (plus and minus) 22 volts to the ... had some instructions on diagnosing by entering display   5   Video   and    TV Power on the remote as quickly as possible. I pressed ...

    CWB - 07/27/2007 - 01:30 - 330 comments

  9. Defalt reset on Philips DVD726 without video feed

    ... My kid was playing with the remote and I lost my video feed. Unit loads and plays with sound but I don't get a picture on my set. I'm ... Press OK once. 4. Press the > cursor (right cursor) once. 5. Press the down cursor 5 times (for good measure). 6. Press OK once (you ...

    iggabon - 10/09/2005 - 09:05 - 1 comment

  10. Sony Wide Screen Model KP-57WS510

    ... where the big fat red wire is attached. I removed 5 screws from the board which was holding the board down. I am thinking that ... You can ohm out the two pico fuses that feed the +22v and -22v to the STK chips. The pico fuses are located at the ...

    Brewer - 04/10/2007 - 12:45 - 39 comments

Pages

 

Connect With Techlore