OUR NETWORK:Dijit Community Explore3DTV My Open Router DVRplayground MediaSmart Home See all... About UsAdvertiseContact Us

 
Learn about scoring Forum's Raw Score: 2.56722E7
October 4, 2007 09:45 AM

Categories: Televisions and Projectors

Rating (10 votes)
  • 1
  • 2
  • 3
  • 4
  • 5
Rate This!

Member Avatar

Speed

Member
Joined: 09/29/2007

Larry & Riley, I received the WS-65813 service manual that you sent and replaced the 4 CAPS on the DM Module with 1000uF, 35V, 105c capacitors. Verified cap polarity and proper solder connections. Upon power up, have the same issue: continuous "Blinking Green Light". Reset button has no effect. The unit makes NO unusual sounds. Could the eeprom board be bad. Is it labeled "E2P" on the DM circuit board. Any suggestions regarding where I might� obtain a replacement eeprom or other circuit board parts.� Do you have any additional troubleshooting advice. Your suggestions are appreciated.

By way of information, I sent a letter to Mitsubishi's Consumer Relations Department with a copy to Mitsubishi's President and CEO discussing this issue.�  vicnlinda@hotmail.com

Speed

The following link has been added to this thread: http://www.techlore.com/article/24711/Mitsubishi-Blinking-Green-Light-Repair-... Follow the repair procedure discussed in this Article to replace bad capacitors. A service manual link is provided for those in need of a Mitsubishi Service Manual for your specific Model. Good luck in the repair.

Discussion:    Add a Comment | Comments 101-125 of 1681 | Latest Comment | « Previous 1 2 3 4 5 6 7 868 Next »

November 24, 2007 1:25 PM

I am having the blinking green light problem on my WS-65713. Can you please send me all the info I need to fix this problem? I hope it is easy because I am not very electronic component smart. Thank you Larry.  Email: b.underwood@cox.net

-Brandon

November 24, 2007 2:54 PM

Brandon, try to find someone who can solder, or pay an expert to do it cause you have one chance to save this board. If you damage the printed circuit, you will have to buy a very expensive board, i am sending you the info. Good Luck

"Those who do not know their opponent's arguments, do not completely understand their own".

**For complete TV repair kits including parts goto www.TvRepairKits.com

November 24, 2007 9:49 PM

Larry:

I have a WS-65813.  I think a tech. replaced the caps while it was still under warantee.  I would like to replace them just to see if this cheap repair does the trick.  If it doesn't work I think it will be time to upgrade to new technology.

 Could you please send me the instructions on the cap replacement?

Many thanks

Ken

November 24, 2007 11:51 PM

Larry:

I forgot to give you my email.

ken@hendrixtech.com

Thanks,

Ken

November 24, 2007 11:55 PM

Will do Ken, Good Luck

"Those who do not know their opponent's arguments, do not completely understand their own".

**For complete TV repair kits including parts goto www.TvRepairKits.com

November 25, 2007 11:44 AM

Larry, I am having the same blinking green light issue with my WS55613 Mitsubishi. Can you send me the info you have been providing the others on this forum regarding the caps? Thanks, Duane

Larry not sure if you missed my original post but I have not received the info yet.


drweber3@mac.com

November 25, 2007 12:34 PM

Larry, looks like I am having the same blinking light problem with my WS-65813.  However, this is at least the third time but previous to this time I have been able to eventually reslove the problem by simply unplugging set several times or holding down the power button.  Set would then work great for 7 or 8 months before problem would happen again.  Any ideas on what that was all about? Regardless could you please send me the cap replacement info. 

Thanks,

Rick

srsykes@verizon.net

November 25, 2007 2:22 PM

Larry,

Me too!

Same problems - need drawings and please define: DM Module.  What does it mean?

My Model number is WS-48613

Email: kswiatkows@aol.com

Thanks!  (In advance!)

thedad

November 25, 2007 8:09 PM

Hello everyone, I have a WS65813 and I have the same problem. I was wondering if someone has already gotten the manual and directions for replacing the DM caps from larry? Or if Larry you could send this info to me. Thanks all Mike. Mwonger1@earthlink.net

November 25, 2007 10:27 PM

I will be sending the service information out to you all soon, on the next mailing. Good Luck

"Those who do not know their opponent's arguments, do not completely understand their own".

**For complete TV repair kits including parts goto www.TvRepairKits.com

November 26, 2007 10:47 AM

Just to let everyone know.  I have a WS-65813.  It had the blinking green light DM issue.  I removed the DM Module, replaced the four caps and re-installed the board only.  I did NOT re-insert the board back into the cage out of which it came.  I just made sure that the copper fingers that were at one time touching the side of the cage did not touch the board.  I did this by bending the one on the left side so that it pointed straight up.  The TV works GREAT!

November 26, 2007 12:22 PM

The metal case is on the board for a reason. Yes it may work now, but you may get interference without it at one point. You really should reinstall the case. That's my pro opinion. Sealed

"Those who do not know their opponent's arguments, do not completely understand their own".

**For complete TV repair kits including parts goto www.TvRepairKits.com

November 26, 2007 6:36 PM

Larry Dillon said: cantaim, I have sent you the documents. Make sure the board is seated well into the board below the DM board. Also read the article, it explains about some small surface mounted fuses that go bad sometimes also. Good Luck

Larry,

I have the same blinking green light with my WS-65713.  Do you have a service manual and/or repair instructions on how to replace the four capacitors?  This seems to be a problem to all these Mitsubishi projection TVs.  I would appreciate any help you can provide.  Thanks in advance.  My email is jose91946@sbcglobal.net.

 Jose

November 26, 2007 9:51 PM

Larry Dillon said: Speed, You will need to contact an authorized Mitsubishi parts house and ask them, as the manual does not even have a schematic or parts list for the DM board, only a part number for the entire board. I have never replaced the eeprom board in one of these TV sets. If the Caps do not fix the problem, I'm afraid the only option is to replace the DM. Good Luck

Larry:  I am a pending new member, having found you today when searching for help related to my green light blinking on Mitsubishi WS-65813 - was told that it was not repairable, but that I needed to get the DM Board replaced for big money.  Your information seems to imply that we could get the DM Board functioning by replacing the CAPS.   Do you have instructions to email me to assist in that repair process?  Obviously if I can fix it that way, I win....

David Russomano    jagxprt@sbcglobal.net

November 26, 2007 10:26 PM

Jagxprt and Jose, I will get those documents you need, INCLUDING the free factory service manual out to you tonight. Good luck with this repair.

Larry

"Those who do not know their opponent's arguments, do not completely understand their own".

**For complete TV repair kits including parts goto www.TvRepairKits.com

View unverified member's comment - posted by champ333

November 27, 2007 1:47 PM

Champ I just sent out the info you need for your TV set. Good Luck

"Those who do not know their opponent's arguments, do not completely understand their own".

**For complete TV repair kits including parts goto www.TvRepairKits.com

November 27, 2007 7:34 PM

Larry,

Have the continuous blinking light for Model No. WS-55613.  Can you send the repair instructions for the dm board to michael_welfl@hotmail.com?  Thanks!

November 27, 2007 8:55 PM

Sure man, I am sending the documents out in just a little bit tonight. Good Luck with this repair!

"Those who do not know their opponent's arguments, do not completely understand their own".

**For complete TV repair kits including parts goto www.TvRepairKits.com

November 27, 2007 10:34 PM

Larry Dillon said: I am sending you the documents you requested, Good Luck

Larry,

Can you please send me the documents? I have a WS-65813 model with a blinking green light to which the reset button does nothing for. jody.bull@lyondell.com

November 27, 2007 10:59 PM

They are on there way dabull! Good Luck with the repair!!

"Those who do not know their opponent's arguments, do not completely understand their own".

**For complete TV repair kits including parts goto www.TvRepairKits.com

View unverified member's comment - posted by Stallworth

November 28, 2007 2:56 AM

They are on there way ss. Good Luck with this repair.

"Those who do not know their opponent's arguments, do not completely understand their own".

**For complete TV repair kits including parts goto www.TvRepairKits.com

November 28, 2007 9:52 AM

Hello Larry, 

Like all the others I'm having the green blinking light problem.  The first few times it came back to life, the last time it took hours for the light to stop blinking but it did come back, now it just continues blinking.  I have model # WS-65613.  If you would please send me any information on how to fix this problem, and/or the service manual, I would appreciate it very much.  My email is sheedevil@juno.com

Thanks!  :)

November 28, 2007 11:57 AM

Nice Picture She*devil. I am mailing out the documents you requested along with the service manual. Good luck with the repair.

"Those who do not know their opponent's arguments, do not completely understand their own".

**For complete TV repair kits including parts goto www.TvRepairKits.com

Discussion:    Add a Comment | Back to Top | Comments 101-125 of 1681 | Latest Comment | « Previous 1 2 3 4 5 6 7 868 Next »

Add Your Reply

(will not be displayed)

Email me when comments are added to this thread

 
 

Please log in or register to participate in this community!

Log In

Remember

Not a member? Sign up!

Did you forget your password?

You can also log in using OpenID.

close this window
close this window