I have a service manual for the KP-53XBR200 TV set, and this has the same chassis (RA-4) that the KP-65XBR10W has.  I would be happy to share it with you if you like.  You will need to go to pando.com and download the free program to read this file I am going to share with you.  That is the only way I can send such a large file, as my e-mail provider does not hand larger files.  Also the six blinks means that the H-stop is active.  That is the horizontal stop circuit.  This could be due to bad capacitors in the sweep supply, a bad High Voltage block, a bad regulator.  Lots of things can cause this.  Good Luck and let us know how this turns out for you and if you want the service manual.

"Those who do not know their opponet's arguments, do not completely understand their own".

Larry, how are you? Your site was of great help on a MITS dlp, so I will pass on a Sony quandry. RA4 chassis -- replaced flyback and shorted HOT transistor. Will make high voltage, 30 kv at flyback HV wire end, as running while connected to picture tubes.

When showing video, as from an off-air channel, within say 15 seconds, it will drop high voltage, blinking 7 times. When showing, it has good video. If screen is reduced, it will give 5 blinks, but 7 is most common if showing picture before quiting.

 Wish I had noted location numbers, but perhaps you have seen this before. I don't have it in front of me, but here is what I scoped, going by item placement, board viewed from front end, not cable jack end. a small transistor, driving horizontal pulses to h drive transformer, just behind hv reg connector that comes from splitter - when started, has horizontal pulses at input and output. When quits, no h pulses of course. Following base line of this transistor up, I find 2 small surface mount resistors. At this junction, hor pulses remain after hor pulses quit at the small transistor. I have changed both it and the hor drive transistor, just to see. I can provide better location numbers later, just wanted to run it across you.

I questioned the blue tube, and swapped with a known good one. Same results. All do have good bright video when working.

Thanks, Danny

Larry Dillon said: I have a service manual for the KP-53XBR200 TV set, and this has the same chassis (RA-4) that the KP-65XBR10W has.  I would be happy to share it with you if you like.  You will need to go to pando.com and download the free program to read this file I am going to share with you.  That is the only way I can send such a large file, as my e-mail provider does not hand larger files.  Also the six blinks means that the H-stop is active.  That is the horizontal stop circuit.  This could be due to bad capacitors in the sweep supply, a bad High Voltage block, a bad regulator.  Lots of things can cause this.  Good Luck and let us know how this turns out for you and if you want the service manual.

CAN I PLEASE GET A COPY OF THE SEVICE MANUAL? I HAVE A KP-53XBR200 AND THE SOUND RECENTLY HAS VERY LOW OUTPUT.  OR IF YOU HAVE ANY SUGGESTION, I AM ALL EARS.

THANKS,

TONY

Larry Dillon said: Tony, STOP shouting at me man!

I was not shouting.  I am at work and the system we use has to be typed in caps.  I always make the mistake and leave the caps on when working on other things.  Sorry for that.

Tony

Request every one to provide me with a service manual for my SONY colour
TV Moddel KV2197 PF.

what type offree asdvise o lookinkink fot msn/

"Those who do not know their opponet's arguments, do not completely understand their own".

what type o advice?

"Those who do not know their opponet's arguments, do not completely understand their own".