OUR NETWORK:TiVo Community Sling Community RoboCommunity My DigitalEntertainer MyOpenRouter MediaSmart Home See all... About Us Advertise Contact Us

RCA CTC197HA ,F27680GY.Help

Previous Thread | Next Thread

Learn about scoring Forum's Raw Score: 84222.3

January 26, 2007 05:45 PM

Categories: Televisions and Projectors

Rating (0 votes)

Rate This!

Silva

Member
Joined: 11/18/2006

Hi Larry it's me again. Again with RCA CTC197AH. You remember i sad that it would worked fine after ajusted the RED BIAS no more bleeding, but it would run fine for 40 minutes and then the horizontal goes out keeping good sound, no pic, if i unplugg from wal and let it sit for some time and try again it come up for same cycle.I just learnd correct me if i'm wrong,>There is an ERROR code,when i enter the service menu #1,#2,#3,are ERROR CODES.and #1 sais 10,and the other two say 0. also i got the code list and it sais 10, this code means FPIP power supply at reset,what you guys think any ggestions

Discussion: Add a Comment | Comments 1-3 of 3 | Latest Comment

Larry Dillon

Expert

member since: 06/17/2006
rank: 1 of 26119
10 articles authored
10 forum threads started
7973 comments

January 26, 2007 7:19 PM

I think your losing your horizontal drive. Did you do the coil modification on the base of the horizontal output transistor? You must take the coil that connects up the base of the horizontal output transistor with the secondary of the horizontal drive transformer. You must scrap off the enamal and reinsert the coil and resolder. Simply resoldering the small coil will fix it temporaraly, but it will go out again, so you must do as I said. The coils is L14401. Good Luck

"Those who do not know their opponet's arguments, do not completely understand their own".

Silva

Member